How to Stop on a Longboard? Ultimate Guide 2021


We’ve all seen people flying on longboards in the street. You could have given it a try yourself at some point – and why shouldn’t you? The speed and the rush of adrenaline – combined with the wind blowing through your hair – can be a fantastic experience for all ages. An essential part, however, is how to come to a complete stop. How to stop on a longboard can be a tricky experience, but with the right amount of training, you will dominate the hills and reach maximum speeds.

Table of Contents
    Add a header to begin generating the table of contents

    How to stop on a longboard without gloves

    Furthermore,  knowing how to stop and brake on a longboard is just as essential. And for security, it’s more than necessary. To brake and stop, the techniques are few and not too challenging to acquire. Some of these include:

     1. Stop pushing: This is the easiest way, although not a technique and not the most effective.

    2. Jump off the board: This is the most improper technique. It sometimes hurts and may end you up in the hospital if you are not a master of the board, moving without proper footwear or knee pads. They work for some braking where there are no other options.

    3. Rubbing the tail on the ground: It requires a little balance, but the idea is to put the tailor the heel on the ground to break. It works pretty well, it’s fun, but it uses way too much the tail (or the heel of the shoe or both).  Also, this technique is reserved and to be applicable for ultra-smooth surfaces and boards provided with a tail bone. Some allow you to make sparks as well.

    4. Slow down with your foot on the ground: This is precisely the same technique as for pushing except that instead of suspending your pushing, the propelling foot will press on the ground while acting as a foot brake and dampen the speed. This technique is relatively easy to acquire and works well.

    5. Slow down by sliding the front foot: This is an excellent way on how to stop on a longboard sliding. Here, the propelling front foot touches the ground as if to push except that the sole rubs against the field. It increases friction and slows down.

    With this technique, caution is essential.

    Because by being poorly positioned, you can hurt your knee, and above all, it wears out the soles if you are not wearing proper footwear.

    6. Derail: This is the excellent power sliding technique, and is quite sufficient to use. All directions favor the skid, but it’s the front of the board that it is the easiest. Here, you have to lean back, turn a bit, and slide the wheels. For this, we carry out weight on the wheels on the “rear” side.

      Note that this is much easier on a super smooth floor or a wet floor, but you must watch out for back falls that can hurt your buttocks and wrists.

    7. Brake on the blunt-slide: This is not a beginner technique. It involves making a powerslide, but only on two wheels.


    Longboarding is a fun and healthy activity, but you ought to learn how to stop to avoid injuries and accidents, as highlighted above.